Waking the display and putting it in standby

If the display is in Standby mode, you can wake it by pressing the Power button on the front control panel or remote control.

If the display’s input source is set to HDMI2 and a computer is connected to the HDMI2 input, the display wakes automatically whenever the computer wakes.

See  Adjusting source, image mode, audio mode, and menu settings

To return the display to Standby mode, press the Power button on the front control panel or remote control.

To return the display to Standby mode, press and hold the Power button on the front control panel or remote control for three seconds to begin a 10 second countdown before the display enters Standby mode.

Note 

When the display is connected to an external input that has had no active signal for one hour, it begins a 60 second countdown before it enters Standby mode.

Note 

When the display is connected to an external input that has had no active signal for 5 minutes, it begins a 10 second countdown before it enters Standby mode.

For information about turning off the display, see Turning the display on or off

Related documents