Turning the display on or off
In most situations, you can put the display in Standby mode when not using it by following the instructions in Waking the display and putting it in standby.
In most situations, you can put the display in Standby mode when not using it by following the instructions in Waking the display and putting it in standby.
In most situations, you can put the display in Standby mode when not using it by following the instructions in Waking the display and putting it in standby.
In some situations, such as when you move the display or clean its screen, you need to turn the display off. You can turn it back on after.
To turn the display off
Press the Power button on the front control panel or the remote control for five seconds and wait for the status light to stop blinking.
Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the OFF (O) position.
SBID-GX165
SBID-GX175 and SBID-GX186
Press and hold the Power button on the front control panel or remote control for three seconds to begin a 10 second countdown before the display enters Standby mode and the status light stops blinking.
Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the OFF (O) position.
To turn the display on
Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the ON (I) position.
Press the Power button on the front control panel or the remote control for five seconds.
Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the ON (I) position.
To turn the display on or off (with an OPS module installed)
If OPS is currently set as the Boot input Source input (see Source settings), the OPS module will start automatically when the display is turned on.
If PC is currently set as the default input in display settings (see Startup and shutdown in System), the OPS module will start automatically when the display is turned on.
Before turning off the display, turn off the OPS module using the power controls on the OPS module (such as the Shut down command in the Windows 10 start menu on the OPS).
When the OPS module is turned off, it is then safe to turn off the display using the steps listed above in To turn the display off.