Turning on and turning off the display
In most situations, the display enters an energy saving mode when not in use.
In some situations, such as when you transport the display or clean its screen, you need to turn the display off. You can turn it back on after.
You can also restart the display.
Waking up the display and putting it back in Standby modeIf the display is in Standby mode, you can wake it by pressing the Power button
on the front control panel or remote control.
To return the display to Standby mode, press and hold the Power button on the front control panel or remote control for three seconds to begin a 10 second countdown before the display enters Standby mode.
Note
When the display is connected to an external input that has had no active signal for 5 minutes, it begins a 10 second countdown before it enters Standby mode.
Turning the display off and turning it back onTo turn the display off
Press and hold the Power button
on the front control panel or remote control for three seconds to begin a 10 second countdown before the display enters Standby mode and the status light stops blinking.Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the OFF (O) position.
To turn the display on
Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the ON (I) position.
To turn the display on or off (with an OPS module installed)
If PC is currently set as the default input in display settings, the OPS module will start automatically when the display is turned on.
SeeStartup and shutdown in System
Before turning off the display, turn off the OPS module using the power controls on the OPS module (such as the Shut down command in the Windows 10 start menu on the OPS).
When the OPS module is turned off, it is then safe to turn off the display using the steps listed above in To turn the display off.