Moving the interactive flat panel to the installation site
After your organization receives the interactive flat panel, you need to move it to the place where you plan to install it.
On occasion, you might also need to move the interactive flat panel to another location after initially installing it.
Important
Move the interactive flat panel at your own risk. SMART cannot accept liability for damages or injury that occur during the interactive flat panel’s transportation.
When moving the interactive flat panel:
Follow local safety regulations and standards.
Pack the interactive flat panel in its original packaging, including the pallet.
Move the interactive flat panel so that its top frame faces up.
Have at least two people move the interactive flat panel.
Tip
Interactive flat panel packaging may be labeled to indicate which side is the front. Look for “FRONT” on the packaging to help orient the box during transportation.
You can use the following aides to move the interactive flat panel:
Cart
Furniture dolly
Mechanical lift
Note
Larger, heavier models feature eyebolt mounting holes for use with a mechanical lift. Refer to these models’ installation instructions for information about using a mechanical lift.
In some situations, you might need to remove the interactive flat panel from its packaging to move it through narrow doorways or hallways or onto an elevator. In these situations, keep the foam pieces on the bottom corners of the interactive flat panel. These foam pieces protect the interactive flat panel if you need to set it down during transportation.
You might also need to rotate the interactive flat panel so that its top frame faces to the side. You can do this during transportation, but when you install the interactive flat panel, it must be in landscape orientation (with the top frame facing up).
The interactive flat panel contains safety-tempered glass. Although this glass is heat-strengthened to help withstand impacts, the glass can crack, chip or shatter if struck with enough force. (Safety glass is designed to break into small pieces rather than sharp shards if it is broken.) Temperature changes can cause a minor crack or chip to become worse, possibly causing the glass to shatter. See the knowledge base article, Shattered glass on an interactive display, for information about conditions that can cause the interactive flat panel’s glass to shatter even when it’s not in use.
If the interactive flat panel’s glass is cracked or chipped, have it professionally inspected and repaired at a SMART authorized repair center. If the interactive flat panel’s glass shatters, carefully clean up the area and have the interactive flat panel repaired or replaced.
Warning
For safety and to prevent further damage, do not continue to install or use the interactive flat panel if its glass is cracked, chipped or shattered.
Save the original packaging and repack the interactive flat panel with as much of it as possible if you ever need to move the interactive flat panel after installation. This packaging was designed to provide the best possible protection against shock and vibration.
Note
If the original packaging isn’t available, you can purchase the same packaging directly from your authorized SMART reseller (smarttech.com/where).
Caution
Move the interactive flat panel only in the original packaging or replacement packaging purchased from your authorized SMART reseller. Moving the interactive flat panel without correct packaging can lead to product damage and voids the warranty.