Waking up your display and putting it back to sleep

The display’s occupancy sensor (SBID‑7000‑V2 models) or sensors (SBID‑7000 models) can detect people up to 16' (5 m) away when the display is in Sleep mode. Depending on how the display is configured, it either turns on or enters Ready mode when the sensor or sensors detect people.

If the display is in Ready mode, you can turn it on in a number of ways:

• Press the Power button on the convenience panel.

• Pick up a pen or the eraser.

The display returns to a partial sleeping state when one of the following occurs:

• The sensors detect no motion in the room for 60 minutes.

• You press the Power button on the convenience panel.

The display remains in this partial sleeping state until all pens are fully charged. The display enters a full sleeping state after all pens are fully charged and the sensor or sensors don’t detect anyone in the room.

For information about turning off the display, see Turning the display off and back on.