Connecting power and turning on the display for the first time

The final step in installing and configuring the display is to connect power, turn the display on, and configure iQ (if the display has iQ) following the steps in the wizard.

To connect the display to power

  1. Connect the supplied power cable from the AC power inlet on the back of the display to a power outlet.

    55" and 65" models

    75" models

    86" models

    Note 

    Refer to the display’s specifications for power requirements and power consumption information.

    SeeSpecifications

To turn on the display for the first time and configure iQ (if the display has iQ)

Important 

The display needs an internet connection for downloading and installing important updates. Ask the network administrator to confirm that the network has been correctly configured for iQ.

SeeConnecting to a network

Notes 

  • Touch is not available immediately after waking or turning on the display. Wait a few seconds, and then the display will respond to touch.

  • If a USB drive is connected to the display’s service port receptacle, do not remove the USB drive. The USB drive may contain an important firmware update.

  1. Flick the switch beside the AC power inlet to the ON (I) position.

    55" models

    65" models

    The power switch is located on the rear of the display.

    75" and 86" models

    The power switch is located on the rear of the display.

  2. If the display has iQ, follow the steps in the wizard to configure iQ.

    SeeSet up iQ 4 for the first time

Related documents