Waking up your display and putting it back in to an energy saving mode

The display’s proximity sensors can detect people up to 16' (5 m) away when the display is in an energy saving mode. Depending on how the display is configured, it either turns on or enters Ready mode when the sensors detect people.

Note 

The sensors can detect people through glass. Consider this when finding a location for the display (see Choosing a location). Don’t position the display so that the sensors are facing a window.

If the display is in Ready mode, you can turn it on in a number of ways:

  • Press the Power button on the convenience panel or the remote control.

  • Pick up a pen or the eraser.

The display returns to an energy saving mode when one of the following occurs:

  • The sensors detect no motion in the room for 60 minutes.

  • You press the Power button on the convenience panel or the remote control.

The display remains in this energy saving mode until all pens are fully charged. The display enters a full energy saving mode after all pens are fully charged and the sensor or sensors don’t detect anyone in the room.

For information about turning off the display, see Turning off, turning on, and resetting the display.

Related documents