Turning off, turning on, and restarting the display
In most situations, you can put the display in an energy saving mode when not using it following the instructions in Waking up your display and putting it back in to an energy saving mode.
Note
On 65" models of the SMART Board 6000S (V3) display, it will take approximately 30 seconds before an image appears on the screen and the convenience panel buttons begin to respond after you flick the power switch beside the AC power inlet to the ON (I) position.
In some situations, such as when you transport the display or clean its screen, you need to turn the display off. You can turn it back on after. You can also restart the display.
To turn the display off
Press the Power button
on the convenience panel or the remote control for five seconds.A slider appears on the screen.
Move the slider to the right.
Flick the switch beside the AC power inlet to the OFF (O) position.
Note
Wait at least 30 seconds before turning the display back on.
To turn the display back on
Flick the switch beside the AC power inlet to the ON (I) position.
Press the Power button
on the convenience panel or the remote control.
To reset the display
Press and hold the Power button
on the convenience panel or the remote control for 10 seconds.Note
Resetting the display does not change any user settings or delete saved files.
The display resets.