Using your SMART electric height-adjustable mobile stand

Warning 

  • Ensure the locking bolts are securely tightened before operating the stand.

  • Do not allow the stand to be used by children or by people who cannot operate it safely.

  • Lock the casters before raising or lowering the stand.

  • Allow adequate clearance above and below the stand to ensure safe raising and lowering.

  • To prevent injury, keep hands and people away from crush and pinch locations on the stand.

To raise the stand

  1. Press and hold the up button on the control panel.

  2. Release the up button to stop raising the display.

To lower the stand

  1. Press and hold the down button on the control panel.

  2. Release the down button to stop lowering the display.

Warning 

  • Do not move the floor stand while external cables are connected or when the power is on.

  • Secure all cords and cabling before you move the stand.

  • Two or more people are required to move the stand.

  • Move a stand-mounted display with care. Quick stops, excessive force and moving over uneven surfaces may cause the stand to overturn.

To move the stand

  1. Shut down the mounted display and accessories.

  2. Press and hold the down button on the control panel until the display reaches its lowest position.

  3. Flick the power switch on the power bar to the off position.

  4. Unplug the stand from the power outlet and secure all cables.

  5. Flip the caster brakes up to unlock them.

  6. Carefully push the center point of the legs to move the stand. Do not push on the upper part of the stand as this might cause it to tip over.

  7. After the stand is moved, flip the caster brakes down to lock them and secure the stand in place.

  8. Connect the power cable to the outlet and secure any cables that run along the floor.

Models

  • FSE-300

Keywords

  • raising the stand
  • lowering the stand
  • moving and resetting the stand

Related documents