Assembling the stand
The stand requires assembly. Consult the SMART electric height-adjustable floor stand illustrated installation instructions (docs.smarttech.com/kb/171906) included with the stand for assembly instructions.
Refer to theImportant safety instructions (docs.smarttech.com/kb/171939) included with the stand for full safety information.
Warning
Failure to follow the installation instructions included with the stand could result in personal injury or product damage.
Caution
Ensure any display you install on the stand weighs no more than
Environmental requirementsBefore installing the stand, refer to the following environmental requirements.
Caution
Do not operate the stand immediately after moving it from a cold location to a warm location. Allow the stand to reach room temperature before operation to prevent possible product damage.
Do not place the stand in hot locations, such as near heating equipment.
Considerations when assembling the standWarning
Two people are required to safely assemble the stand and to mount or remove the display.
Lock the casters before installing or working with the display on the stand or adjusting its height.
Use only a junior service thermoplastic (SJT) power extension cord with 16 AWG conductor size minimum.
Only use the stand with a nominal 120-volt circuit that has a grounding plug that looks like the plug in the illustration below.
Only connect the stand to an outlet that has the same configuration as the plug.
Notes
You require ample work space to assemble the stand.
Do not set up or use the stand in an area with excessive levels of dust, dirt, humidity, or smoke.
Install all Accessories before mounting the display.