Assembling the stand
The stand requires assembly. Consult the illustrated installation instructions included with the stand for assembly instructions.
Warning
Failure to follow the installation instructions included with the stand could result in personal injury or product damage.
Caution
Ensure any display you install on the stand weighs between
Environmental requirementsBefore installing the stand, refer to the following environmental requirements.
Caution
Do not operate the stand immediately after moving it from a cold location to a warm location. Allow the stand to reach room temperature before operation to prevent possible product damage.
Do not place the stand in hot locations, such as near heating equipment.
Considerations when assembling the standWarning
Two people are required to safely assemble the stand and to mount or remove the display.
Lock the casters before installing or working with the display on the stand or adjusting its height.
Notes
You require ample work space to assemble the stand.
Do not set up or use the stand in an area with excessive levels of dust, dirt, humidity, or smoke.
The use of the included WM-SBID-200 wall mount is required for some models of display:
Model(s) | Recommendation |
|---|---|
SMART Board GX Series SMART Board GX (V2) 65" models SMART Board GX (V2) 75" models SMART Board MX Series SMART Board MX (V4) 55" models SMART Board MX (V4) 65" models SMART Board QX Pro 65" models SMART Board 6000 Series SMART Board 7000 Series | The wall mount isn’t required. |
SMART Board 6000S Series SMART Board 7000R Series SMART Board GX (V2) 86" models SMART Board GX (V4) Plus 75” models SMART Board GX (V4) Plus 86” models SMART Board MX (V4) 75" models SMART Board MX (V4) 86" models SMART Board QX Pro 75" models SMART Board QX Pro 86" models | The wall mount is required. |