Important information
Failure to follow the instructions shipped with your SMART product could result in personal injury and damage to the product.
Ensure that any cables extending across the floor to your SMART product are properly bundled and marked to avoid a trip hazard.
To reduce the risk of fire or electric shock, do not expose the SMART product to rain, moisture, or fire.
Do not push foreign objects into the openings on your SMART product.
Do not open or disassemble the SMART product. You risk electrical shock from the high voltage inside the casing. Opening the casing also voids your warranty.
The camera arm on your SMART product has joint that present a pinch hazard when your move the camera arm. Keep clear of the pinch points.
Do not stare into the light or shine the light directly into someone’s eyes. Turn off the light when displaying or capturing images of people.
Do not overload power outlets or extension cords as this can result in a fire or electric shock.
Turn off and disconnect your SMART product before a thunderstorm. During a thunderstorm, do not touch your SMART product or the plug, because there is a risk of electrical shock.
Only use your SMART product with the type or power source that is written on the power supply and do not modify the plug.
Do not short circuit or allow contract with conductive objects to the battery terminals.
Do not disassemble batteries.
Place your SMART product on a solid surface to prevent it from falling.
If you have a security cable attached to your SMART product, do not carry or swing your SMART product by the security cable.
Do not connect non-shielded interface cables to your SMART product and do no leave cables connected to unused connectors, because this can cause interference level that exceed FCC regulations.
Avoid setting up and using the SMART product in an area with excessive levels of dust, humidity and smoke.
Do not block or cover the opening or slots on your SMART product. These slots provide ventilation, ensure reliable operation and protect your SMART product from overheating.
Do not carry your SMART product by the camera arm. Carry it by the base of the unit.
Do not aim the camera lens at the sun.
If your SMART product requires replacement parts, make sure the service technician uses replacement parts specified by SMART Technologies or parts with the same characteristics as the original.
Ensure that batteries are stored in a cool and dry place.
Do not discard batteries in water, fire, or domestic waste. Dispose batteries at collection points.
Remove the batteries in the remote control if you are not in for an extended period of time. Battery corrosion or leakages can damage the remote control.
Do not mix new and used batteries.
Do not mix different types of batteries: alkaline, nickel-cadmium (rechargeable), or carbon-zine.
Models |
|
Keywords |
|
Related documents |